Автор: nizar-maoukil 27.12.2014, 6:08
Hi to all
my ETL hc08 programmer seams to be not working at all it's always give me error like PTA 0 must be in high state
and i need to fix't but and don't know how pleaz i need help
regards
Автор: Saveliy 27.12.2014, 12:18
Цитата(nizar-maoukil @ 27.12.2014, 7:08)
PTA 0 must be in high state
This gap. Pin on the processor are not burned?
Checked vias on the board or on board programming adapter have contact?
Автор: nizar-maoukil 27.12.2014, 23:44
Цитата(Saveliy @ 27.12.2014, 13:18)
This gap. Pin on the processor are not burned?
Checked vias on the board or on board programming adapter have contact?
i have tested more than 4 mcu and i have the same error everytime
thanks m8
what do u think ????
Автор: Saveliy 28.12.2014, 0:06
Цитата(nizar-maoukil @ 28.12.2014, 0:44)
what do u think ????
I think the bad adapter. I had the same thing. The problem in via pad on board adapter.
Автор: nizar-maoukil 28.12.2014, 3:12
Цитата(Saveliy @ 28.12.2014, 1:06)
I think the bad adapter. I had the same thing. The problem in via pad on board adapter.
ok i well order a new adapter
regards
thanks alot m8
Автор: Saveliy 28.12.2014, 3:37
Цитата(nizar-maoukil @ 28.12.2014, 4:12)
ok i well order a new adapter
You first try on the board to ring track multimeter...
Автор: nizar-maoukil 8.3.2015, 22:51
Hi again
i have changed the adapter white a new one tested of corse and still not working, plz do you have any idea about mt probleme
regards
Автор: Saveliy 8.3.2015, 22:56
Your ETL HC08 is defective..
You have an original device?
Автор: nizar-maoukil 9.3.2015, 17:15
Цитата(Saveliy @ 8.3.2015, 23:56)
Your ETL HC08 is defective..
You have an original device?
i have a clone device
regards