[X] Помощник

[tomo776]

Hi
I have problem vith this dash from lancia thesis i try to change km in dash and now got eol error
No dash is : 51732540
I read with upa usb eeprom L56R and save org shange km put back and got error.
Now when i put old dumo same.
I need org dump from this dash
lancia is 2003 year.
THANX advance
Regards Tomo

I find dump on cardamp.ru but i can not download

Отредактированно tomo776 - 26.6.2014, 12:25

[Zmeiarm]

u must pay for dump, this is not expensive. u must prepaid in your account some manye and after this u can download

[tomo776]

Ok thanx
Is it km just in dash or i need ro change in ecu also?
Thanx

Отредактированно tomo776 - 26.6.2014, 13:36

[Easy]

Ok thanx
Is it km just in dash or i need ro change in ecu also?
Thanx

You should only do dash

[tomo776]

But when i connect dash on desk km its ok show km on dash
But when i connect dash on car i have error
I dont understand why and i think that is only
I try now in ecu also and see what whil show

[Easy]

But when i connect dash on desk km its ok show km on dash
But when i connect dash on car i have error
I dont understand why and i think that is only
I try now in ecu also and see what whil show

And when you connect a dash on the table, you see that run that put you?

[tomo776]

I change in ecu km and the same.
Again error.
Here is my dump from dash if someone verify that its ok.
Thanx for answer

Прикрепленные файлы

  org_93c56.bin ( 256 B )
      Кол-во скачиваний: 7

[Zmeiarm]

238496km ?

[tomo776]

No car have 1192xx But on dash dond work any gauge fo fuel rpm.
I dont have any idea what can be so i need org dump for compare.
I think that i need to read like 93S56 not like i did C56.
But i dont know why when i put that orgh file is the same gauge not work and on displey EOL Error.
Do any have some idea what should i do.
THANX

[Easy]

No car have 1192xx But on dash dond work any gauge fo fuel rpm.
I dont have any idea what can be so i need org dump for compare.
I think that i need to read like 93S56 not like i did C56.
But i dont know why when i put that orgh file is the same gauge not work and on displey EOL Error.
Do any have some idea what should i do.
THANX

You read like 93c56 or 93c56 * 16?

[tomo776]

I read like c56
Upa read same c56 or c56x16.
I have upa usb v1.1

Отредактированно tomo776 - 26.6.2014, 18:00

[Easy]

I read like c56
Upa read same c56 or c56x16.
I have upa usb v1.1

you have to do swap dumpa.

[tomo776]

Ok i try now and report.

[tomo776]

With this file gauge work but again error
I need oround 550 000 km if you can make this to work
Thanx

Прикрепленные файлы

  93C56_x16_gauge_work_but_error.bin ( 256 B )
      Кол-во скачиваний: 11

[Voron2033]

you incorrectly read a memory chip.

[Voron2033]

you need to look for the correct file only. To write down as 93S56.93C56 93S56 are read with honors